HOW TO: Set up for Action Photography

Following on from the last blog that covered what gear to use for wildlife photography, I’m going to explain how I set up my X-Series cameras for capturing action. Though some cameras are better than others for this type of photography, there are little ways to help yourself help improve your chances of capturing action.

High burst rate

Though using a high burst rate will eat through your memory cards space, shooting at a high frame rate will hopefully get a good selection of action shots.

Auto focus

First of all make your focus point as large as possible: do this by pressing the AF button and zooming out as far as you can. With a moving subject it will be very difficult to keep the subject in a small selection zone, so give yourself the best chance possible. Continuous focus (This applies to the X-T1 and X-E2 as they have vastly improved continuous AF functionality) is really helpful with certain subjects, especially if they are coming towards you. For those of you with models that are best in single focus mode, fear not! Generally the Fujifilm lenses are quick to auto focus so if you’re following a subject you can focus, take a shot and then focus again or alternatively prefocus if you know where the subject it going to go. Some photographers use cameras in MF mode and use the AFL/AEL button to focus. This is helpful because you can then use the manual focus ring on the lens and see what is in focus via focus peaking. Experiment and see what method works best for you.

2 / 12

This sequences was taken using the X-T1’s tilting screen and the XF56mm at F2.8.

ISO

My standard ISO setting is 800. To some this might seem high but the output from this is so clean that it isn’t a concern for me. If it’s a bit cloudy and I’m wanting to freeze the action I’ll push my ‘ready’ ISO to 1600. My philosophy is that it is better to have a sharp image that might be slightly noisy as you get up to than an image that might have some motion but has less or no noise.

A blue shark close up taken at ISO 1600

100% close up – In my eyes the noise (or lack of it) is not a problem at ISO 1600

Aperture

For action photography you have to decide if you want to freeze a moment, capture the motion or something in the grey area. If you want to freeze the action you’ll generally want to use a wider aperture to get a sufficiently high shutter speed. The shutter speed required to freeze depends on the pace of the action, and your chosen aperture is determined by the light conditions and your ISO choice. The thing to remember is that shutter speed, aperture and ISO are all intertwined. If you want to read more on apertures then read this previous blog (it contains puppies!). If you want to focus on one, say a faster shutter speed, then this has an adverse affect on the other two factors. If you’re wanting to freeze the action with a fast shutter speed AND also have a large depth of field then you have to increase the ISO. It is also about prioritising the most important factor for you and then compromise with the others. When aiming to freeze the action I am generally in aperture priority mode, where I have set the ISO according to the conditions (usually over 800), and I then choose an aperture to obtain the shutter speed I want.

Taken at 1/3800 sec, F5.6, ISO 800

If you want to capture motion blur, say through panning with your subject, then your shutter speed is having less of a constraint on your ISO and aperture so you can change these accordingly to reduce your shutter speed. One way to control this is through shutter speed priority, where you set shutter speed to what you want and then have the aperture in auto mode so it will change to keep the same low shutter speed (with the ISO previously set).

Taken at 1/13 sec, F16 ISO 200

Finally, another set up option for action is to set the aperture and shutter speed to what you want and then have the ISO in automatic mode. You could go fully manual but I find this can quickly lead to problems when trying to capture action, especially if there is a lot going on around you. This method can result in you missing fleeting moments.

Now that you know some action set ups go out and shoot! Let us know what your action set up is with the X-Series and share with us your action shots via our Fujifilm’s Facebook and Twitter. As ever, if you have any questions then please leave a comment below or contact me via:

Twitter – @benji_cherry

Facebook – https://www.facebook.com/BenCherryPhotography

Author: Ben Cherry

Ben is an environmental photojournalist, zoologist and Fujifilm X-Photographer. His passion is showing the beauty and fragility of the natural world. Find more of his work at www.bencherryphotos.com

One thought on “HOW TO: Set up for Action Photography”

  1. A question regarding ISO on the XT-1… if I set fixed aperture and shutter speed (manual mode) but set ISO to Auto, exposure compensation is disabled. The camera is selecting an ISO based on metering, so it could apply my exposure compensation setting to the selected ISO value?

Leave a ReplyCancel reply